Bissell SpinWave Wet and Dry

amazon Bissell SpinWave Wet and Dry reviews

Bissell’s SpinWave Wet and Dry Robot can both vacuum and scrub your floors to make them truly shine.

Although Bissell has been making vertical wet and dry vacuums for years, the $399.99 SpinWave Wet and Dry is its first robot that can do dual duty. It’s a solid vacuum that reliably sucks debris from low-quality carpets and hard floors. It shines when it comes to mopping, with two microfiber pads that rotate and support several different cleaning solutions to remove dirt keep your floors looking as good as new. Plus, it can automatically detect and avoid carpets and carpet areas when mopping, a feature typically only found on much more expensive models. It lacks voice home mapping and voice control support, but it delivers better performance than any other 2-in-1 in this price range.

SpinWave’s Wet and Dry Feature

SpinWave is 12.25 inches in diameter and 3.25 inches tall, a pretty standard size for a robot vacuum cleaner. It’s one of the more attractive models I’ve seen — I like its all-white design, as it matches my home decor much better than most robotic vacuums, which are usually black, blue, or gray.

Adding to the sleek aesthetic is an attractive light ring surrounding the top, indicating the robot’s status. When charging, the light ring pulses once, then “breathe” (pulsed slowly) for 30 seconds before turning off. A smaller light on the Start/Pause button will illuminate while the robot is charging. When the robot is fully charged, the Start/Pause button will light up.

The robot comes with a dry bin for vacuuming and a bucket for mopping. The wet bucket has two circular mop pads on the bottom that rotate to scrub hard floors with detergent solution or plain water. Bissell makes some different solutions you can use when wiping, including multiple surfaces, multiple pet surfaces with Febreze, and disinfectant formulations.

Bissell only uses its cleaning solution brand, as other formulations can harm the robot and void the warranty. In the box with the SpinWave, you get an 8-ounce bottle of multi-surface floor cleaner, an extra set of reusable mop and edge brushes, and extra trash can filter. The company sells 32-ounce bottles of cleaning solution starting at $9.99.

Most other 2-in-1 mops and mops, including the $799.99 Ecovacs Deebot Ozmo T8 AIVI, support water only and are not recommended for use with cleaning solutions. The $499 iRobot Braava Jet m6 works with a cleaning solution, but the iRobot only offers one formula, and it doesn’t double as a vacuum.

SpinWave Control

Bissell says to place the charging dock at least 40 inches away from objects on either side and anything over 40 inches away. You’ve plugged in the charging dock and plugged it in. Please turn it on with the switch on the side, and place the robot on the dock. The first charge takes four to five hours.

While it’s waiting for charging, you can download and connect the robot to its companion app so you can control it from your phone. SpinWave doesn’t come with a separate remote, so you’ll need to use the app to take advantage of all its modes and features.

The setup process is very simple. Download the Bissell Connect app (available for Android and iOS) and log in or create a new account. The app will first ask a few questions about what kind of clutter in your home (dogs, cats, kids, and others). What needs to be cleaned (floors, carpets), stairs, upholstery, and car/garage), and what features are important to you (allergen control, eco-friendly cleaning, and lightweight products).

From there, it will guide you through the setup process. Click Get Started, select SpinWave Robot from the list, turn it on if you haven’t already done so, and press OK. The app will then guide you to locate the QR code under the trash and scan it with your phone to initiate the pairing process.

To turn on SpinWave’s Wi-Fi, power on the device using the side switch, then hold the start/pause button for five seconds until you hear a beep. Then a pop-up asks you to join SpinWave’s Wi-Fi; accept this request, then enter your home Wi-Fi password to connect the robot to your network, and the robot will complete the pairing process. For me, the process only took a few minutes.

It is worth mentioning that the robot had a connection problem at one point during testing and was not working with the app. I had to remove it from the app, then do the setup again, then it worked fine.

Using the app, you can change the cleaning pattern of the robot (Automatic or Spot). Select suction power or water flow level (Low, Medium, Max); start, stop or pause remotely; send it back to its base station; schedule cleaning; see notices; track your cleaning history, and fix errors. When creating a schedule, you can choose the date, time, and suction power or water flow rate. The robot will vacuum or mop the house at the set time, depending on whether you have installed the dry or wet tank.

In the cleanup history section, you can see the date and duration of each session. The app also tracks uptime stats like distance, duration, and total cleaning jobs.

Since high-end floor mopping robots can cost upwards of $1,000, you can’t expect a $399.99 model to include every feature under the sun, and SpinWave doesn’t offer home mapping or support voice assistant. Higher-end hybrids like the $749 Roborock S6 MaxV can map your home and let you create virtual no-go zones. The S6 MaxV and more also support Amazon Alexa, Apple Siri, and Google Assistant, so you can start and stop cleaning with just your voice.

where can you get a Bissell SpinWave Wet and Dry online

Bissell SpinWave Hard Floor Expert Pet Robot, 2-in-1 Wet Mop and Dry Robot Vacuum, WiFi Connected with Structured Navigation, 3115: Buy it now

BISSELL SpinWave Wet and Dry Robot Vacuum, WiFi Connected with Structured Navigation, 28599: Buy it now

Vacuum and mop with SpinWave

In vacuuming mode, SpinWave provides suction power up to 1,500Pa, allowing for easy collection of pet hair, dust, and other debris from low-quality carpets and rugs, as well as hard floors. Suppose you primarily have carpet in your home. In that case, especially if it’s a medium to high-density material, you’ll likely be better served by a robot with higher suction power, such as the Proscenic M7 Pro (2,600Pa) $499.

Like most robot vacuums, the SpinWave has a main brush roll on the bottom, along with dual-edge cleaning brushes.

In Auto Mode, the robot cleans in a straight line and automatically returns to the base when the battery is low. In Spot mode, the robot cleans in a spiral, covering an area of ​​about 40 x 40 inches in five minutes.

Bissell’s official battery life estimate is up to 100 minutes, which is pretty good but not outstanding. On its first test run, the SpinWave vacuumed for 77 minutes on Auto mode before the battery ran low, and it successfully navigated back to its docking station. It ran for an impressive 166 minutes in a follow-up test, even though it got tucked under my TV stand and needed my help. (When it has a problem like this that it needs assistance, the robot will beep loudly to let you know.) I believe the 166-minute result is an anomaly, and the robot may not have been cleaned up the whole time, as it picked up the same amount of debris in 77 minutes as it did in 166 minutes. After both sessions, SpinWave’s 13.5-ounce trash can contain a fair amount of dog hair and dust, but it wasn’t nearly full.

If you’re looking for a hybrid robot with outstanding battery life, check out the Deebot Ozmo T8 AIVI, which lasts 170 minutes — longer than any other robot vacuum we’ve tested. It also has artificial intelligence technology that automatically identifies and avoids obstacles automatically, so it rarely gets stuck, although it’s also twice as expensive as SpinWave.

While it performs well as a vacuum cleaner, the SpinWave is far superior to a mop. While mopping, SpinWave simultaneously sweeps, collecting a limited amount of dry debris. But for best results, you should run it as a vacuum before sending it out to mop.

To refill the mop bucket, turn the cover to the unlocked position and remove it. There are two lines next to the tank; one marked Water and one marked Recipe. First, fill the reservoir with Water to the Watermark, then add a small amount of Bissell’s solution until you reach the Formula line. Then screw the mop bucket cover back into place and slide the bucket into the robot.

One of the things I like about SpinWave is that it automatically detects and avoids carpets in mopping mode. When it reaches the edge of a carpet in the area under test, it simply turns around in the other direction. It’s a surprisingly rare and useful feature — the only other mop I’ve tested with this capability is the Deebot Ozmo T8 AIVI. Like the $500 Proscenic M7 Pro, some let you create virtual boundaries, so they avoid certain areas when mopping, but it can be tricky to trim area rugs with this method. No-frills models like Yeedi K700 do not offer such features, and their manufacturers instead recommend folding the edge of the area rugs under themselves to prevent the robot from rolling over them while mopping; This is not a great solution.

Thanks to its multi-surface cleaning formula and dual rotating pads, SpinWave leaves my floors shinier after one swipe than any other floor mopping robot I’ve tested. Other robots that mop with just Water and an immobile pad tend to leave streaks and take a few runs to get your floors shiny. SpinWave achieved that result in just one pass, leaving both the laminate in my living and dining room and the tile in my kitchen looking clean and stain-free. As a bonus, the multi-surface cleaning solution is scented.

In mop mode, the SpinWave cleans for 81 minutes, after which its pads are filled with dirt.

At the end of the job, the SpinWave got stuck on the transition strip between my living room and my kitchen floor, but I just poked the robot with my foot and set it free, then it went back to the dock without happening trouble. When you’re done mopping, you can remove the pads on the bottom of the wet bin and toss them in the trash or the washing machine.

Most of the time, you’ll probably run it on Auto, so it wipes everywhere, but Bissell recommends using Spot mode with its disinfecting formula to clean up concentrated piles of junk, like pet accidents. To do this, place the robot in the center of the area you want to clean, then select Spot mode in the app. Your floor will probably be wet and slippery after running SpinWave in Spot mode, so be careful until it dries.

One of SpinWave’s other strengths is its low volume. When vacuuming and mopping, it’s quieter than a lot of other models I’ve tested. For example, I left it running while calling Zoom, and it didn’t bother me.

Like most floor mopping robots, SpinWave requires regular maintenance, including emptying and rinsing the dustbin every few sessions and periodically cleaning the broom shaft and wheels. You will also need to clean the edge brushes from time to time or replace them altogether to maintain optimal performance. Bissell provides maintenance instructions in its SpinWave user manual and instructional videos in its application.

It’s easy to empty the trash, but doing so exposes you to dust and other allergens. If you have allergies, I recommend choosing a robot capable of emptying the trash automatically, such as the Roomba i3 + $599.99. If you’re looking for a hybrid model with auto-empty capabilities, check out the Deebot Ozmo T8 AIVI or the Proscenic M7 Pro. Neither type comes with an automatic vacuum cleaner, but you can purchase one separately for $249.99 or $100, respectively.

For glittering floors

With the ability to both mop and vacuum, the Bissell SpinWave Wet and Dry offers a lot of value for its $399.99 price tag. It works quickly and quietly, sucking up pet hair and dust from hard floors and low carpets. Swap trash cans for wet bins, and the robot will run around hard floors, scrubbing them clean with a dual-rotating mop and pleasant-smelling cleaning solution while avoiding carpets and area rugs.

Most 2-in-1 floor mopping robots cost a lot more, and several competitors in this price range, including the $349.99 Yeedi K700 and the $249.99 iLife V8S, offer no controls application. SpinWave allows you to start, stop and schedule cleaning sessions from your phone, and provides far superior cleaning.

Advantages

Wipe and vacuum

Working with cleaning solution

Automatically avoid carpet when cleaning

Quiet

Defect

No mapping or voice control features

The robot got stuck on some furniture during testing.